NRS U-Style Raft Motor Mount

1 5/8-in 6063-T6 anodized aluminum frame pipe
2-NRS frame pipes with LoPro fittings, 6-U-bolts with nuts and washers
18-in wide and 24-in piece of frame pipe with frame plugs

NRS U-Taste Raft Motor Mount – The U-Taste Raft Motor Mount by NRS places the motor a ways enough from the raft’s stern for simple operation of the keep watch over maintain. Constituted of heavy-duty 1-5/8 inch OD 6061-T6 aluminum pipe, this is a good selection if you have a heavy motor. The curved bars rest against the raft’s tubes to make stronger the load. The wide transom plate is fabricated from a Picket/plastic composite decking subject material for you to now not rot or go to pot when exposed to water and sun. It’s sponsored with two items of aluminum channel to extend the grip at the upright pipe sections, even as four oversize U-bolts hold the transom plate firmly in place. All the time attach a security rope or strap out of your motor to the frame. When you wish to have to run your motor even as sitting at the stern seat, you wish to have the NRS U-Taste Raft Motor Mount.
1 5/8-in 6063-T6 anodized aluminum frame pipe
2-NRS frame pipes with LoPro fittings, 6-U-bolts with nuts and washers
18-in wide and 24-in piece of frame pipe with frame plugs
Picket/plastic composite decking transom plank
Fits raft tubes 18-in to 24-in in diameter, wishes Stern Seat Mount (sold one by one)

Reviews

There are no reviews yet.

Be the first to review “NRS U-Style Raft Motor Mount”

Your email address will not be published. Required fields are marked *